Installing CCCam on an Amiko receiver (such as Amiko Mini HD SE, Mini Combo, HD 8265+, Alien, etc.) allows you to watch encrypted satellite channels using a CCCam line. Follow this step-by-step guide to install and configure CCCam on your Amiko device.

🔹 Requirements:

✅ Amiko receiver (Mini HD SE, Mini Combo, HD 8265+, etc.)
✅ Valid CCCam subscription (CCCam line details)
✅ USB flash drive (for loading CCCam.cfg) or internet connection
✅ Amiko remote control

🔹 Step 1: Connect Your Amiko Receiver to the Internet

Before configuring CCCam, ensure your receiver is connected to the internet:

1️⃣ For Wi-Fi:

• Go to Menu > Network > Network Settings.
• Select Wi-Fi, choose your network, and enter the password.

2️⃣ For Ethernet:

• Simply connect an Ethernet cable from your router to the receiver.

🔹 Step 2: Access CCCam Setup Menu

1️⃣ Press the Menu button on your remote.
2️⃣ Navigate to Conditional Access > NetClient Config.
3️⃣ Select CCCam from the protocol list.

🔹 Step 3: Add CCCam Line Manually

If you received your CCCam details in a text format (e.g., C: s1.fullcccam.eu 12000 user pass), enter them manually:

1️⃣ In NetClient Config, go to an empty slot and press OK.
2️⃣ Enter the following details:

• Server Address: (e.g., s1.fullcccam.eu)
• Port: (e.g., 12000)
• Username: (your CCCam username)
• Password: (your CCCam password)
• Des Key: (usually 0102030405060708091011121314 if required)
  3️⃣ Press Save and then Activate the CCCam line.

🔹 Step 4: Load CCCam.cfg via USB (Alternative Method)

If you have a CCCam.cfg file, you can load it from a USB flash drive.

1️⃣ Copy the CCCam.cfg file to a USB drive.
2️⃣ Insert the USB into your Amiko receiver.
3️⃣ Go to Menu > Conditional Access > NetClient Config.
4️⃣ Select Read CCCam.cfg from USB.
5️⃣ The system will automatically import your CCCam line.

🔹 Step 5: Activate CCCam

1️⃣ In NetClient Config, go to your CCCam server line.
2️⃣ Highlight it and press OK to Activate it.
3️⃣ Restart your receiver.

🔹 Step 6: Test Channels

1️⃣ Switch to an encrypted channel.
2️⃣ Wait a few seconds for decryption.
3️⃣ If the channel opens, your CCCam is working! 🎉

🔹 Troubleshooting

🛑 No channels opening?

• Ensure your CCCam line is active.
• Check your internet connection.
• Restart your receiver and try again.

🛑 CCCam line not connecting?

• Verify your CCCam details (server, port, username, password).

🛑 Receiver not reading CCCam.cfg from USB?

• Ensure the file is named correctly as CCCam.cfg.
• Format the USB drive to FAT32 and try again.

🎯 Final Thoughts

After following these steps, your Amiko receiver should be running CCCam successfully. Enjoy your satellite channels with smooth decryption! 🚀📡