Installing CCCam on an Amiko receiver (such as Amiko Mini HD SE, Mini Combo, HD 8265+, Alien, etc.) allows you to watch encrypted satellite channels using a CCCam line. Follow this step-by-step guide to install and configure CCCam on your Amiko device.
🔹 Requirements:
✅ Amiko receiver (Mini HD SE, Mini Combo, HD 8265+, etc.)
✅ Valid CCCam subscription (CCCam line details)
✅ USB flash drive (for loading CCCam.cfg) or internet connection
✅ Amiko remote control
🔹 Step 1: Connect Your Amiko Receiver to the Internet
Before configuring CCCam, ensure your receiver is connected to the internet:
1️⃣ For Wi-Fi:
- Go to Menu > Network > Network Settings.
- Select Wi-Fi, choose your network, and enter the password.
2️⃣ For Ethernet:
- Simply connect an Ethernet cable from your router to the receiver.
🔹 Step 2: Access CCCam Setup Menu
1️⃣ Press the Menu button on your remote.
2️⃣ Navigate to Conditional Access > NetClient Config.
3️⃣ Select CCCam from the protocol list.
🔹 Step 3: Add CCCam Line Manually
If you received your CCCam details in a text format (e.g., C: s1.fullcccam.eu 12000 user pass), enter them manually:
1️⃣ In NetClient Config, go to an empty slot and press OK.
2️⃣ Enter the following details:
- Server Address: (e.g., s1.fullcccam.eu)
- Port: (e.g., 12000)
- Username: (your CCCam username)
- Password: (your CCCam password)
- Des Key: (usually 0102030405060708091011121314 if required)
3️⃣ Press Save and then Activate the CCCam line.
🔹 Step 4: Load CCCam.cfg via USB (Alternative Method)
If you have a CCCam.cfg file, you can load it from a USB flash drive.
1️⃣ Copy the CCCam.cfg file to a USB drive.
2️⃣ Insert the USB into your Amiko receiver.
3️⃣ Go to Menu > Conditional Access > NetClient Config.
4️⃣ Select Read CCCam.cfg from USB.
5️⃣ The system will automatically import your CCCam line.
🔹 Step 5: Activate CCCam
1️⃣ In NetClient Config, go to your CCCam server line.
2️⃣ Highlight it and press OK to Activate it.
3️⃣ Restart your receiver.
🔹 Step 6: Test Channels
1️⃣ Switch to an encrypted channel.
2️⃣ Wait a few seconds for decryption.
3️⃣ If the channel opens, your CCCam is working! 🎉
🔹 Troubleshooting
🛑 No channels opening?
- Ensure your CCCam line is active.
- Check your internet connection.
- Restart your receiver and try again.
🛑 CCCam line not connecting?
- Verify your CCCam details (server, port, username, password).
🛑 Receiver not reading CCCam.cfg from USB?
- Ensure the file is named correctly as CCCam.cfg.
- Format the USB drive to FAT32 and try again.
🎯 Final Thoughts
After following these steps, your Amiko receiver should be running CCCam successfully. Enjoy your satellite channels with smooth decryption! 🚀📡